HVAC Permit — 421 VINE ST

Work Description

Addition and/or Alterations - EZ PERMIT DUCTWORK & WARM-AIR APPLIANCES - For the installation of New Ductwork, Registers/Grilles/Diffusers, and Warm-Air Appliances as per attached standards. Deviations from these standards require submission of construction and site plans. Mini split unit shall be installed in a place that is not visible from surrounding public rights of way. Conduit for line shall be made as minimal as possible, shall hug the inside corner of the building and not run up the center of the wall, and shall be painted to match the wall it is installed on(As per PHC conditions). Install (1) mini-split low wall console in the top floor art studio, rear side wall. Linesets/ linehide to enter into the home in the rear 3rd floor bedroom. They will be externally mounted then fish across the room and into the front closet. From the front closet they will continue to run upward into the 4th floor studio. Outdoor Unit will be located: in the rear side corner patio of the home. New copper refrigerant lines and communication wire will run from the outdoor unit to the indoor units. Exterior wall mounted linesets will be wrapped in a UV resistant, tear-proof, fully insulated, copper sleeve protection and encased in a PVC White decorative/ protective linehide system. Electrical line will be reconnected to the new outdoor unit. A new Whip & Safety Disconnect will be installed outside in the location next to the outdoor unit.